17
FERITSCOPE® DMP30
Technical Data
Applications
Determination of delta-ferrite content of austenitic and duplex steel
Determination of deformation martensite in austenitic materials
Finding weld seams in polished surfaces
Capturing a ferrite content profile along the weld seam
Metrological Features
Measurement acquisition
Default: After each placement of the probe onto the surface, a measured read-
ing is automatically recorded
Scan mode: While probe is moving over the surface the measured readings are
automatically recorded according to the defined time interval and number of
measurements.
Indication of measurement acquisition
Audible by a short beep, can be disabled
Visual by colored illuminated strip (green: measured value recorded)
Haptic feedback by gauge vibration, can be disabled
Limit violation: 2 short beeps, red illuminated strip and gauge vibration
Measured reading between the limits: 1 short beep, green illuminated strip and
gauge vibration
Measurement performance
Measurement speed, measurement range, trueness etc. depend on connected
probe, you will find these data in the respective probe data sheet
Grouping measured readings
Block (group) size can be set between 1 and 1000 single readings
Storage of measured readings
Can be disabled
Measurement unit/Measurand
FN or Fe%
To Next Page
Loading...
