FISCHER FERITSCOPE DMP30

To Next Page

To Previous Page

FERITSCOPE® DMP30 Measure

Correction curves for measurement values with measurement unit FN

Correction values for values with measurement unit FN measured on specimens with different

convex curvature diameters

Measured value [FN]

Correction value k

Diameter convex [mm]:

Main Page

Table of Contents3
Safety7
Warnings and Icons Used7
Intended Use8
Safety of the Electrical Equipment8
Maintenance and Repairs10
Disposal10
Limitation of Liability11
Description11
Scope of Supply11
Gauge12
Overview of Signals13
Softkey - Icons/Codes13
Measurement View15
Display Icons/Codes15
Menus - Function Overview18
Statistical Characteristic Variables21
Technical Data22
Data Transmission27
Protection Class28
Visual Indications28
Order Information29
Guide31
Rechargeable Battery32
Changing the Battery32
Before You Start32
Charging the Battery34
To Charge the Battery34
Connecting/Replacing Probe36
Connecting the Probe36
Replacing the Probe - Connecting a Different Probe38
Settings for Measurement40
Creating a New Batch40
Opening a Batch41
Activating/Deactivating Specification Limit Monitoring41
Activating/Deactivating Automatic Block Formation42
Activating/Deactivating Offset Function43
Selecting Measuring Mode44
Save Measured Readings On/Off46
Air Reference Value - Automatic/Manual Acquisition46
Assigning a Different Calibration to the Opened Batch47
Measure48
Notes on Measuring48
Handling the Probe49
Parameters that Influence the Delta-Ferrite Content Measurement50
Before You Start53
Measuring in Single Reading Measuring Mode - Procedure54
Measuring in Free-Running Measuring Mode - Procedure55
Measuring in Scan Measuring Mode - Procedure56
Measuring with Manual Recording of the Air Reference Value57
Calibration58
Overview of Calibration Methods59
Please Observe the Following Information on Calibration/Recalibration60
Calibration - When Is It Necessary60
Recalibration61
Required Material62
Calling up Information about the Calibration66
Activating/Deactivating Semi-Automatic Calibration Routine67
Calibration - Reset68
Creating New Calibration69
Calibration - Assigning/Changing Names70
Checking the Precision of a Calibration71
Important to Know71
Defining the Test Criteria for the Calibration Check74
Lock Calibration75
Calibration - Deactivating Lock76
Deleting a Calibration77
Deleting All Calibrations78
Evaluation79
Batch Statistics79
Block Statistics80
Individual Measured Readings80
Data Transfer81
Data Transfer Via USB82
Data Transfer Via Bluetooth83
Batch Settings85
Calling up Information about the Open Batch85
Selecting the Measurement View for the Batch87
Selecting Characteristic Variables for the Statistical Displays88
Setting the Decimal Places for the Display Values89
Batch Management90
Assigning/Changing Batch Names90
Copying a Batch90
Deleting a Batch91
Gauge Settings92
Setting the Language92
To Select the Language92
To Change the Display Settings92
Signal Settings - Visual and Audible Signals93
Energy Saving94
Activating/Deactivating the Bluetooth Function94
Date & Time95
Default Settings for Decimal Places96
Activating/Deactivating Lock Code96
Reducing Electromagnetic Interference on the Measurement97
Service98
Gauge Cleaning98
Gauge Information99

FISCHER FERITSCOPE DMP30 - Page 51

Table of Contents

Related product manuals