FLIR DM286 USER MANUAL Document Identifier: DM286-en-US_AA
3. Introduction
Thank you for selecting the FLIR DM286 True RMS Digital MultiMeter with IGM (Infrared
Guide Measurement) and METERLiNK. The DM286 can measure voltage up to 1000V
AC/DC and includes Low-Z (low impedance) and VFD (low pass filter) modes. This device
is shipped fully tested and calibrated and, with proper use, will provide years of reliable
service.
3.1 Key Features
• 6000-count 2.8 in. (7.1 cm) digital TFT display
• Built-in IGM Infrared imager (120 x 160 pixels) with laser pointer and crosshair targeting
• Capture fully radiometric thermal images
• Bluetooth METERLiNK connectivity for sharing images, video, and data log files with mobile
devices
• Measures Voltage, Current (A, mA, µA), Frequency, Resistance/Continuity, Diode,
Capacitance, and Temperature
• Built-in non-contact voltage detector (NCV)
• Customizable via easy-to-use menu system
• Data logger stores up to 40,000 readings
• Gallery mode for displaying stored images/video and data log files
• Automatic and Manual ranging
• Input over-voltage warning
• MIN-MAX-AVG memory
• PEAK MIN and PEAK MAX AC V and AC mV measurements
• Flex Clamp direct input
• On-screen programming menu navigation
• Variable-frequency drive VFD mode (low-pass filter)
• Low-Z (low impedance) mode
• Relative mode
• Data Hold
• Auto Power OFF for meter and worklight separately
• Safety Category Rating: CAT IV-600V, CAT III-1000V.
• Equipped with two TA04 rechargeable batteries, CAT IV-600V test leads, CAT IV-600V
alligator clips, Type-K thermocouple (-22 to 500
o
F [-30 to 260
o
C]) with adapter, USB cable,
storage pouch, warranty card, and Quick Start booklet.
To Next Page
