Victor Xu Page 11 12 Jan. 2011
Copyright 2011 © Shenzhen Runtianzhi Image Technology, Co., Ltd.
http://www.floradigital.com
Chapter 2 - Pre-install
2.1 Getting Started
This section provides the necessary information to operate the printer. Familiarize yourself with
the basic of the printer before reading Section 2.
Contents of this section：
− Operating conditions
− Consumables
− External Views, Part Names and Functions
2.2 Operating Conditions
This section describes the operating conditions for the printer.
2.2.1 Installation Space
There must be sufficient space around the printer for the replacement of frequently
used parts, for the output of the printed media and for ventilation. In addition, maintenance
space, shown below, is required to repair the printer or replace components.
2.2.2 Environment Conditions
2.2.2.1 Operating temperature and humidity levels
The printer should be used within the temperature and humidity ranges as shown
below;
Temperature: 20 ºC to 30 ºC
Humidity: 30% to 70%
To obtain better print quality, use the printer within temperature of 20 ºC to 25 ºC.
When the operating temperature is lower than 20 ºC or higher than 40º C,
printing speed is reduced to two-thirds of normal print speed to maintain good
print quality.
2.2.2.2 Places where the printer must not be installed
Do not install the printer in the following places:
A location near a fire
Places exposed to direct sunlight
Places subject to vibration
Places with excessive dust
Places subject to extreme changes in temperature or humidity
Places near an air conditioner or a heater
Places where the printer may get wet
Places near a diazo copier that may generate ammonia gas
Places with poor ventilation
Unstable place
2.3 Consumables
To Next Page
Loading...
