Victor Xu Page 9 12 Jan. 2011
Copyright 2011 © Shenzhen Runtianzhi Image Technology, Co., Ltd.
http://www.floradigital.com
1.2.5 Ink and solvent spillage, a potential risk of Fire and explosion
1.2.6 High voltage may shock people or trigger a fire
1.2.7 Printing media rolls are bulky and very heavy
1.3 Fireproofing
Ink and solvent should be clearly labeled and stored in a specific area for flammable liquid and
should be in accordance with local regulations of fireproof and safety standard. Ensure that the
specified fire extinguisher is always available near the storage area and should be cleared from any
obstacle in case of emergency.
1.4 Exhaust System
The printing area should be equipped with sufficient exhaust system. The exhaust should be
installed in such a way build up of fumes is minimized. Best location for the exhaust should be at lowest
level, this way the fumes build-up is minimized. Solvent fumes are heavier than air, so fumes build-up
concentrates on the lower level of the room.
1.5 Handling Precautions
1.5.1 Power Supply
1. Install the printer near an easily accessible electrical outlet.
2. Do not provide power to the printer through the same power line as for other noise
generating devices such as motors.
3. Use a power supply matched with the printer specification.
4. Connect the power cable directly to an electrical outlet. Do not plug several devices into
• Store ink and solvent in proper cabinet for flammable liquid storage.
• Keep ink and solvent containers tightly closed at all times. If a container
has sign of damage/leakage, fix or replace it immediately.
• Clean ink or solvent spillages as soon as possible.
• Only use dry powder, or carbon dioxide type of fire extinguishers.
• If there’s no emergency power switch which can shut down all the power,
do not connect the printer to main-power supply.
• When the machine’s power is on, do not open the back cover of machine,
or avoid touching electrical parts.
• The printer or other equipments should be grounded, according to the local
safety electrical connection regulation. The ground voltage should be less
than 3 V.
• Set the machine on smooth ceramic tile or cement ground
• Use specified anti-static floor mat to minimize harmful static build-up.
• Wear hand and foot safety protection gear when loading, unloading and
handling media to avoid serious body injuries.
• Use proper heavy duty handling equipment if available.
Electrical installations inside the printing area must be in accordance
with local Electrical Safety Regulation
To Next Page
Loading...
