Juno System: User Guide
Chapter 2: Getting Started with Juno
Start a Run
26
Switch an Interface Plate
You may need to switch interface plates when you change applications or IFCs on the Juno
system. If there is no interface plate installed on the instrument, install the correct one. (See
Install an Interface Plate on page 29 for more information.)
1 On the Start screen, tap TOOLS.
2 On the Tools screen, tap Interface Plate. The Interface Plate screen displays.
3 Tap SWITCH INTERFACE PLATE. The instrument ejects the interface plate:
4 Remove the ejected interface plate from the tray.
5 Clean the interface plate to remove any dust particles or debris. (See Clean an Interface
Plate on page 51.) Store the ejected interface plate in its storage container.
6 Remove the Interface Plate Loading Fixture from its storage tray.
• Swivel-style storage container: Pull the tray at the notch to swing out the loading
fixture:
• Box-style storage container: Take the loading fixture out of the labeled drawer.
7 Ensure that there is no IFC on the tray, then place the loading fixture on it in the direction
of the arrows with THIS SIDE UP facing up. Barcode numbers on the fixture label face
out:
To Next Page
Loading...
