Fluke 43B - Calibration Adjustment

5-1
Chapter 5
Calibration Adjustment
Title Page
5.1 General ........................................................................................................ 5-3
5.1.1 Introduction.......................................................................................... 5-3
5.1.2 Calibration number and date................................................................ 5-3
5.1.3 General Instructions............................................................................. 5-4
5.2 Equipment Required For Calibration.......................................................... 5-4
5.3 Starting Calibration Adjustment ................................................................. 5-4
5.4 Contrast Calibration Adjustment ................................................................ 5-6
5.5 Warming Up & Pre-Calibration.................................................................. 5-7
5.6 Final Calibration ......................................................................................... 5-7
5.6.1 HF Gain Input 1. .................................................................................. 5-8
5.6.2 Delta T Gain, Trigger Delay Time & Pulse Adjust Input 1................. 5-9
5.6.3 Gain DMM (Gain Volt)....................................................................... 5-10
5.6.4 Volt Zero.............................................................................................. 5-12
5.6.5 Gain Ohm............................................................................................. 5-12
5.6.6 Capacitance Gain Low and High......................................................... 5-13
5.6.7 Capacitance Clamp & Zero.................................................................. 5-14
5.6.8 Capacitance Gain................................................................................. 5-14
5.7 Save Calibration Data and Exit................................................................... 5-15