1
Introduction
XWWarning
The information provided in this manual is for the use of qualified
personnel only. Do not perform the verification tests or calibration
procedures described in this manual unless you are qualified to do
so.
This Calibration Manual provides the following information for the Fluke 724
Temperature Calibrator and the Fluke 725 and 726 Multifunction Process Calibrators
(also referred to as "the Calibrator" and/or “the UUT”):
• Precautions and safety information
• Equipment required for performance tests and calibration
• Specifications
• Basic maintenance (cleaning, batteries, and fuses)
• Instructions for using the remote control interface
• Performance test procedures
• Calibration procedures
• List of replaceable parts
For complete operating instructions, refer to the appropriate Users Manual (located on
the CD-ROM shipped with the instrument).
Caution
The Calibrator contains parts that can be damaged by static
discharge. No procedure in this document requires the case to be
opened. If you do so, follow the standard practices for handling static
sensitive devices.
Contacting Fluke
To locate an authorized service center, visit us on the World Wide Web at
www.fluke.com or call Fluke using any of the following numbers:
• USA: 1-888-44-FLUKE (1-888-443-5853)
• Canada: 1-800-36-FLUKE (1-800-363-5853)
• Europe: +31 402-675-200
• Japan: +81-3-3434-0181
• Singapore: +65-738-5655
• Anywhere in the world: +1-425-446-5500
To Next Page
Loading...
Need help?
General
