Fluke 830 - Page 4

830
Users Manual
ii
Checking and correcting soft foot conditions ...................................................................92
Points to be observed during soft foot measurement ......................................................96
8. Alignment options .................................................101
Measurement modes .....................................................................................................101
9. Vertical anged machines ...........................................107
Typical conguration ......................................................................................................107
Set-up ............................................................................................................................108
10. Appendix ........................................................121
Using the sensor cable ..................................................................................................121
Updating the 830 rmware to a newer version ..............................................................124
Sensor rmware update ................................................................................................131
830 Laser Alignment Tool technical data .......................................................................134
Suggested shaft alignment tolerances ..........................................................................136
Declaration of conformity ...............................................................................................137
Index ...............................................................139