AirCheck Wi-Fi Tester
Users Manual
92
Clean the Tester
To clean the display, use lens cleaner and a soft, lint-free
cloth. To clean the case, use a soft cloth that is moist with
water or water and a weak soap.
WCaution
To prevent damage to the display or the case, do
not use solvents or abrasive materials.
Update the Software in the Tester
1
Download the AirCheck update file from the Fluke
Networks website, or contact Fluke Networks to get the
update by other means. Save the file to your hard disk.
2
Get the latest version of AirCheck Manager from the
Fluke Networks website.
3
Start AirCheck Manager on your PC.
4
Turn on the tester.
5
Use the USB cable supplied with the tester to connect
the tester to the PC.
6
In AirCheck Manager, select AirCheck > Update
Software
Note
You can also update the vendor MAC prefix file
(oui_abbr.txt) used to resolve vendor MACs in the
AirCheck device list.
7
Click Select, find and select the update file (.xlf
extension), then click Open.
8
Click Update.
9
When the transfer is completed, disconnect the USB
cable from the tester.
10
The screen on the tester is blank and the tester ticks
while it installs the update file. When the update is
completed, the home screen shows on the tester.
Note
The power key is disabled during a software
update. If you remove the battery before the
update completes, the update starts again when
you turn on the tester.
To Next Page
Loading...
