AirCheck Wi-Fi Tester
Users Manual
88
Save a Test Session
You can save the information the tester has collected since
you turned it on or since the last time you saved a session,
pressed O, or disconnected the USB cable. A session
includes this information:
•
AutoTest results (if saved when exiting AutoTest).
•
Network, access point, client, and channel information
(does not include graphs)
•
A list of clients that transmitted probes
•
Results for the last connection you made
•
Results for the last ping test you did
•
The connection log
To save the data from a test session
1
Press P. The tester shows a default, sequential filename
at the bottom of the screen.
•
To save the session with the filename shown, press
Save. The tester saves the session in the
“SESSIONS” folder.
•
To overwrite a test session that is saved on the tester,
highlight the test session, press L, press Save,
then press OK.
•
To edit the filename, press Edit.
Note
Session names can have a maximum of 8 characters
with an extension of 3 characters. The extension
must be “.ACS” if you want to see the session in
AirCheck Manager.
•
To delete characters in the filename, press
Delete.
•
To add characters to the filename, use to
highlight a character, then press L.
•
To move the cursor in the filename, highlight the
filename, then press .
•
To save the session with the edited filename, press
Done, then press Save.
To see the session file, open it in AirCheck Manager. See
page 91.
To Next Page
Loading...
