AirCheck Wi-Fi Tester
Users Manual
72
Ping a Device or Application Server
You can enter addresses to ping other devices or application
servers (e.g. web servers). This makes sure that other
network devices are accessible and measures the response
time.
1
Connect to a network or access point. See page 68.
2
When the connection is completed, press Start
tests.
Select an IP address from the list or enter a new address.
To enter a new address
a. Select Enter IP address.
b. Use
to select a value to change.
c. Use
to increase or decrease the highlighted
value.
d. To save the address, press
Done.
Note
Up to 10 ping targets can be configured on the
tester.
The ping screen (Figure 20) shows the results of the ping
test. To ping a different address, press twice, then
select or enter a different address.
To Next Page
Loading...
