Fluke AIRCHECK - Discover Clients

AirCheck Wi-Fi Tester
Users Manual
74
 Received: The ping response rate (pings responses
received divided by pings sent).
 Press  Stop tests to stop the ping or TCP Port
Connect test(s).
 The channel that the access point uses. The
color of the bars shows the status of the country code
for the regulatory domain. See “802.11d Operation” on
page 43
 The number of access points that the tester
hears at your location. This shows the number of
physical access points if Group virtual access points is
selected. See page
39.
 Press  Log to see details about the connection
procedure. See Figure 19.
Discover Clients
When the tester is on, it monitors each channel for probe
request frames to discover client devices. To see these
clients, use the Clients button on the home screen.
In addition to the client MAC address, information such as
channels used, data rate, probed SSIDs, the connected SSID
and access point of an associated client are shown.
The client screens include a Locate function to help you find
clients. See page 80.
When an associated client is highlighted in the test. Press
 Access Point Details to see the details of the associated
Access Point.
When you use the Clients function, the tester monitors each
channel for a longer time than when you use other
functions. This lets the tester find more clients on each
channel.
To discover clients
From the home screen, select Clients. Figure 21 shows the
Clients screen.
To see details about a client, highlight the client, then press
L. See Figure 22.
Note
The tester shows the most recent information for a
client only when the client transmits data while the
tester monitors the channel that the client uses. To
collect client information quickly, go to Tools >
Manage 802.11 settings and enable only one band.
This decreases the number of tester monitored
channels.