Maintenance
93
Restore Factory Defaults
Appendix B gives a list of the default settings for the tester.
To restore factory defaults
1
From the home screen, select Tools, select Restore
factory defaults, then press OK.
2
To complete the process, press L, then turn the tester
back on.
Erase All Data
Erase All Data does everything that Restore Factory Defaults
does, plus deleted all the files in the file system.
To totally erase all session data and profiles
1
From the home screen, select Tools, select Erase All, then
press
OK.
2
To complete the process, press L, and then turn the
tester back on.
Device Information
To see information about the tester
1
From the home screen, select Tools > View AirCheck
information.
2
View Memory Used %.
•
Serial Number: The serial number is also shown under
the battery pack.
•
MAC Address: Media Access Control address. The
unique address of the tester.
•
SW Version: The version of software in the tester.
•
Radio Version: The version of the radio in the tester.
•
USB Version: The version of the USB driver in the tester.
If the Tester Will Not Turn Off
If the tester will not turn off, hold down the green power
button for approximately 10 seconds.
If the tester still does not turn off, remove the battery pack
and install it again.
To Next Page
Loading...
