Maintenance
91
Transfer Files to a PC
To use AirCheck Manager to look at test sessions or profiles
that are saved on the tester
1
Install the latest version of AirCheck Manager software
on your PC. Start the software.
2
Turn on the tester.
3
Use the USB cable supplied with the tester to connect
the tester to the PC. The AirCheck pane shows session
files that are on the tester.
To use the PC operating system to transfer files
1
Turn on the tester.
2
Use the USB cable supplied with the tester to connect
the tester to the PC. The PC operating system shows the
tester as a disk drive.
3
Use the PC operating system to copy files from the
tester to a disk drive on the PC.
Maintenance
WWarningX
To prevent possible fire, electrical shock, personal
injury, or damage to the tester:
•
Do not open the case. You cannot repair or replace
parts in the case.
•
Use only replacement parts that are approved by
Fluke Networks.
•
If you replace parts that are not specified as
replacement parts, the warranty will not apply to
the product and you can make the product
dangerous to use.
•
Use only service centers that are approved by Fluke
Networks.
To Next Page
Loading...
