Set Up the Tester
35
all the available profiles.
1
Follow the steps in the procedures above.
2
Move the highlight to the checkbox of your desired
user target.
To navigate, use the and keys.
Note
The highlight must be over the checkbox and not
the user target name or IP address.
3
Press L to add a checkmark to your user target and
mark it for inclusion into the AutoTest.
To remove the checkmark, press Lagain.
Settings
Table 2 describes the different settings and the screens they
affect. Settings are accessed from the Tools screen.
When you change a setting, press
Save to save your
changes. To exit and not save your settings, press
Cancel.
Note
To save your settings in a profile, select
Tools
>
Manage profiles / network passwords > Save profile
or press
Profile from the home screen and then
Save profile.
The profile name is displayed in the
upper-right corner of the home screen. If it displays
with an asterisk *, this indicates a setting change
has been made and the profile has not been saved.
To Next Page
Loading...
