Fluke AIRCHECK - Page 76

AirCheck Wi-Fi Tester
Users Manual
68
1 From the home screen, select Tools, then select Manage
profiles / network passwords.
2 Select Load profile, highlight the correct profile, press
L, then press  Load.
Or
3 Press  Profile from the home screen and then Load
profile.
To connect to a network
1 If the network is secure, you must load a configuration
profile that has security credentials for the network. See
page
29.
2 From the home screen, select Networks.
3 Highlight the network in the Networks (SSIDs) list, then
press  Connect.
To connect to a specified access point
1 If the access point is secure, you must use a
configuration profile that has security credentials for
the access point. See page
29.
2 From the home screen, select Access Points.
3 Highlight the access point in the Access Points list, then
press  Connect.
To do a ping or a TCP Port Connect test
1 Connect to a network or access point, then press 
Start tests.
Note
Ping or TCP Port Connect test targets can be added by
selecting Tools > Manage profiles / network passwords
> Edit targets > Add. You can add a target with an IP
address or hostname (URL).
If an * is on the right of Connect, this indicates
security has not been configured on the tester for
that network. Press Connect* and you are guided
through entering the security settings.