Verify Connectivity
67
7
Highlight the EAP type and press Select.
8
Press Next. The Setup Username/Password screen is
displayed.
Note
Select Done only after you have finished entering
the username and password. If you select Done and
have not finished entering the settings, the
connection will fail. You will then have to select
Tools > Manage profiles / network passwords, select
Edit networks, select the network, and finish
entering the security settings.
9
Press Set username, enter the username using the on-
screen keyboard, and Press Save.
10
Press Set password, enter the password, and press Save.
11
Press Done and the Connect to Network screen is
displayed. AirCheck will then try to connect to the
network and run a series of tests.
Note
AirCheck can only use one set of security credentials
per SSID, even if a SSID has multiple Access Points
with different security settings. Therefore, you may
encounter pressing Connect (no asterisk) and the
connection fails.
To Save the profile with your security credentials
A profile is a file which contains the settings you configure
for the tester. Most settings are configured in the Tools
screen. You can have multiple profiles on the tester, but
only use one at a time.
Once you enter security credentials for an SSID (or multiple
SSIDs), save them to a profile to avoid losing these settings
when the tester is turned off.
1
From the home screen, select Tools, then select Manage
profiles / network passwords.
2
Select Save profile. The profile name displays at the
bottom of the screen.
3
Either select Save or select Edit and change the
profile filename.
To load a profile
To Next Page
Loading...
