AirCheck Wi-Fi Tester
Users Manual
20
Note
AutoTest optionally includes a Rogue Access Point Test which detects and reports rogue
access points. To enable this functionality, go to Tools > Thresholds/AutoTest Settings >
Rogue Access Point AutoTest. For accurate and meaningful test results, you must
configure access point ACLs prior to running AutoTest.
When you save your profile, the assigned ACLs will also be saved as part of that
profile.
You can also set a series of APs to authorized or unauthorized based on the AP
BSSID/MAC or a Vendor MAC prefix by selecting Set AP series to Authorized or
Set AP series to Unauthorized. These options may save you configuration time
and provide quick visibility into potential issues. For example, if a specific
vendor's equipment is not allowed per your network policy, use the vendor MAC
prefix to set the ACL to unauthorized. When those access points are detected,
they will automatically be reported as unauthorized.
To Next Page
Loading...
