l
Tap ( ) to open tasks screen.
l
Tap ( ) to open speed tasks screen.
l
Select task ( ) then tap ADD to assign the task to the speed point.
l
If relative mode was selected, the speed point is merged with a vibration point on the
same machine and shaft. Speed is measured using the vibration signal at this location,
and the speed finder calculates the machine speed.
Speed finder is a method used to calculate the machine RPM. This method is based on
complex algorithms, field tests, and vast experience in vibration analysis.
VIBXPERT 3 69
On-board help
To Next Page
Loading...
