Measure with machine template
l
Before a measure job can begin, make sure that:
The rechargeable battery is fully charged.
The device settings are as necessary.
The necessary sensors and cables are laid out and in good condition.
Permanently mounted measure locations are in good condition. If necessary, clean them
and repair any damage.
Recesses for hand-held probes are prepared.
l
From Machine Templates List, tap necessary template.
The measurement screen of the selected template is shown.
Currently selected measure location
Shows channel and type of sensor to be used to measure
the selected location. The measure channel and sensor
are set in device settings .
VIBXPERT 3 41
On-board help
To Next Page
Loading...
