RFID
Reader module
The device uses RFID – an automatic identification technology to:
l
Identify assets to be measured
l
Let the correct measure locations and their related measure tasks be measured
The device RFID reader module is on the back of device, and is identified by the RFID logo.
Identification is done with provided RFID tags. The tag is attached to an asset. To read the tag
place the device reader module as close as possible to the tag (to within 5 mm if possible
Note:Tags can be read only after the tag has been programmed. The tag can be pro-
grammed at any time.
How to program an RFID tag
The RFID functionality is useful in route measurements where many assets are measured. And
therefore the program function is started in Route List screen.
l
Tap the start screen Routes icon.
30 Version:1.0
On-board help
To Next Page
Loading...
