Fluke VIBXPERT 3 - Near Location; Set up Near Locations

Near location
The objective of near measure locations or to put together measure locations is to monitor the
measure locations at the same time. Measure locations are grouped together and measured
simultaneously. This has the advantage that measured results are comparable as they were
obtained under similar environmental and machine conditions. The measure locations should
be close together.
When two or more locations are measured together, it is possible to find the phase difference
between the locations. To measure phase we need to create near locations.
Note:It is not possible to group measure locations when a route is measured.
Set up near locations
l
Open or create asset to configure then tap the hamburger menu ( ). The screen menu
items are shown.
l
Tap (the Edit menu item). The Configuration screen is shown.
VIBXPERT 3 73
On-board help