Tap the quantity unit ( ) to change the frequency unit used
in the velocity spectrum. Available units are orders (ORD),
cycles per minute (cpm) and Hertz (Hz).
Tap the quantity unit ( ) to change the time unit used in the
time wave. Available units are seconds (s) and revolutions
(Rev).
Overall values
Overall values are a simple way to find out whether the condition of machines gets worse or
not. The overall values shown for a measure location are related to the overall measure tasks
and frequency band for the location.
In this example, the measure tasks and bands for the location M NDE H are shown. These are
the overall values that are shown in results.
VIBXPERT 3 93
On-board help
To Next Page
Loading...
