4
OPERATION
- 97 -
Before taking o
Check the air pressures on the brake
circuits.
CAUTION
Visual and audible warnings are
displayed on the screen when brake air
level is low in the vehicle. Do not bring
the parking brake to drive position and
attempt to drive the vehicle before the
stopping of the visual warning and the
buzzer.
Starting the engine
3
2
1
0
Turn the ignition on.
• Bring the ignition switch to position
2
. Wait until the engine warning lamp is
turned o . Refer to maintenance and
service chapter MIL lamp.
• Switch the engine on by turning the
ignition switch to
3
position while the
gear is at neutral. (allowed for max. 15
seconds)
• Wait for 15 seconds if the engine does
not start and repeat the same procedure
in the same order.
CAUTION
Wait for the period determined by
the electronic control unit (10 to 60
seconds) before starting again a er a
start failure. Do not attempt to start in
this period.
Cold Starting of the Engine
Turn the ignition on. (position
2
) cold
starting lamp shall be continuously on.
• Start the engine (position
3
) when the
cold start lamp turns o ,
• If the engine does not start, switch
the ignition o , wait for 10 minute and
repeat the steps above.
Driving
To Next Page
Loading...
