MAINTENANCE AND SERVICE
5
- 178 -
Engine management is provided by the
state-of-the-art electronic control unit.
CAUTION
Remove the plugs of electronic control
unit before welding on the vehicle.
Otherwise, there is a risk of permanent
damage to the electronic control unit.
Welding operations shall be performed
while the main switch is o .
Running-in
There is no need to perform a special
application in the running-in period of the
engine. Drive the vehicle with the proper
gear so that tachometer remains in the
green zone as always.
Daily Inspections
• Check the coolant level. If the level is
at minimum or less, add 50% distilled
water and 50% antifreeze (WSS
M97B44 D) mixture.
• Check windshield washer liquid level,
add clean water if the level is dropped.
• Check for any oil or liquid leaks in
general.
• Check the operation of the service and
park brakes.
• Drain the water and oil collected in the
air tanks completely by pulling the drain
ring.
Engine
To Next Page
Loading...
