MAINTENANCE AND SERVICE
5
- 190 -
Towing of the vehicle requires specialist
knowledge that is not explained in this
manual. Make sure that the vehicle is
towed by specialist sta .
Draw pin installation location on your
vehicle is on the front grille panel.
Draw pin is designed for installation to the
right-hand side only as standard. Draw pin
system that may be installed to both sides
may be procured as optional if requested
at the time of ordering for the vehicle.
Press the draw pin cover from the side
shown with an arrow. Cover shall rotate
and open. Place it on its seat on the
vehicle and press on it to install the part.
Install draw pin by rotating it clockwise as
shown in the fi gure.
Remove the draw pin and attach the
towing cable.
In order for the vehicle to be towed, the
drive shaft leading to the axle must be
removed from the axle side and fixed to
the chassis.
If the vehicle should be transported on a
trailer with a deep platform, the specifi ed
4m height may be exceeded. Consider
the maximum passing heights of the
underpasses. You may cause an accident.
Towing the Vehicle
To Next Page
Loading...
