Chapter 1 DaqPRO 25
2. Sampling Points
Increasing the number of active inputs limits the number of sampling points one can choose. The
following condition must be always satisfied:
Number of samples × Active Inputs ≤ Memory
DaqPRO’s memory is sufficient for 512,000 samples.
The table below lists the maximum number of sampling point according to the number of sensors:
Number of Sensors Maximum Number of Sampling Points
1 512,000 (exact number: 522,752)
2 256,000 (exact number: 260,608)
3 128,000 (exact number: 129,536)
4 128,000 (exact number: 129,536)
5 64,000
6 64,000
7 64,000
8 64,000
3. Continuous Sampling
• Continuous sampling is possible up to a maximum sampling rate of 1/s
• The data must be presented in a display mode other than Graphic i.e. Numeric
www.esis.com.au
Ph 02 9481 7420
Fax 02 9481 7267
esis.enq@esis.com.au
To Next Page
Loading...