Fourtec DaqPRO 5300 - Special Tools; Crop Tool; To Trim All Data up to a Point; To Trim All Data Outside a Selected Range

78 Chapter 2 Working with DaqLab
2.7. Special Tools
2.7.1. Crop Tool
The Crop tool enables you to trim the edges of a data set. Use it to remove unwanted data.
The time scale of the trimmed data is shifted so that it will start at
0
=
t .
If you want the automatic curve fit equation to start at
0
=
t , apply the crop tool before any type of
curve fitting
After applying the crop tool, the trimmed data set replaces the original set on the graph display and a
new icon is added to the Data Map under cropped data.
1. To Trim all Data Up to a Point
a. Position a cursor (refer to page
37) on the data point.
b. Click on the Graph menu, and then click Crop.
2. To Trim all Data Outside a Selected Range
a. Use the cursors to select the range you want to keep.
b. Click on the Graph menu, and then click Crop.
www.esis.com.au
Ph 02 9481 7420
Fax 02 9481 7267
esis.enq@esis.com.au