15
display the correct moon phase, it is imperative that you enter the
correct date. Otherwise, the displayed information may not be correct.
Setting the Date:
1. Access the Date/Time(r) menu and select “Date.”
2. By default, the first option is the month. Use the scroll buttons
to select the current month and then push the “Play/Select”
button.
3. Next you set the day using the same method described above,
and then push “Play/Select”.
4. Finally, set the year and push “Play/Select” to lock it in.
There are three different date formats that you can choose from
depending upon your personal preference. They are month/day/year,
year-month-day, and day.month.year.
Configuring Date Format:
1. Access the Date/Time(r) menu and select “Date Format”
2. Use the scroll buttons to cycle through the options.
3. When your desired date format is shown, push “Play/Select” to
lock it in.
2-3 Playing Sounds Remotely
The Fusion remote control is not intended to operate the caller at
distances shorter than 1 meter (3 feet). If the remote is located too
close to the caller, proper operation cannot be ensured. Make sure that
you have properly installed batteries in both the Fusion and Fusion
remote as described within Chapter 1. Turn on the Fusion by turning
the volume/power knob clockwise. Turn on the Fusion remote by
pushing and holding the power button for approximately about 1-2
seconds. When powered on, the Fusion display will show three
horizontal dashes. The Fusion remote default view will display the
available categories.
To Next Page
Loading...
