41
6. Sound Settings
The sound settings menu allows you to select how the Fusion plays your
sounds, how the speakers work, and so forth. This section will explore
each of the options, their values, and how they affect operation.
6-1 Volume Step
The Fusion remote has a range of volumes from 0 – 40. Increasing the
volume in the field by increments of 1 may be too slow for some and
therefore this stepping value is configurable. You can choose from 1, 2,
3, and 5. The factory default setting is 2.
Changing the Volume Step Value:
1. Access the Sound Settings menu and select “Volume Step”.
2. Use the scroll buttons to adjust the value up or down.
3. When the desired value is set, push the “Play/Select” button to
lock it in.
6-2 Primary & Secondary (FOXFUSION) Mode
This setting allows you to configure how the primary and secondary
(FOXFUSION) sounds will be played back through the Fusion. There are
three modes of playback: Repeat (default), Single, and Jukebox. In the
default repeat mode, the sound will loop repeatedly every time it ends.
In single mode, the sound will play one time and stop. In jukebox mode,
once the sound has played through entirely, it will then move on to the
next sound in the list.
You can mix the playback modes across the primary and secondary
sounds. For example, you can have one sound repeating on the primary
and then have the secondary operate in jukebox mode stepping
through all the sounds.
To Next Page
Loading...
