17
4. The last step is setting the volume level. Use the volume buttons
to dial-in the desired volume level you wish to assign to this
preset and then push “Play/Select” to lock it in.
5. Your preset is now setup.
You can assign the P1, P2, P3, and P4 buttons in the following manner:
1. Highlight the sound that you wish to have established in one of
the four positions.
2. From the main sounds or category screen, press and hold the
P1, P2, P3, or P4 button for approximately 3-4 seconds.
3. Set the volume level and then push the “Play/Select” button to
lock in that preset.
To initiate playback of preset 1-4, make sure that both the Fusion and
Fusion remote are turned on, and then push the corresponding preset
button (P1 – P4) on the top sides of the remote. The Fusion will then
instantly switch to that sound and volume level.
To initiate playback of any preset, simply select the “Favorites/Presets”
menu on the main screen, browse through the available presets, and
then use the “Play/Select” button, just as if you were picking a sound
for normal playback.
Presets can also be managed by editing a specific file located within the
Fusion remote. For advanced information on this process, please view
Chapter 10.
3. Fusion In-Depth
This section provides detailed information concerning the Fusion charge
jack, external speaker jacks, speaker use, and USB port.
To Next Page
Loading...
