40
the data for future use, make sure that you back up the file prior
to doing a factory reset.
5-8 FOXGRIP
This provides you with the ability to setup a FOXGRIP accessory. To use
the FOXGRIP accessory with your Fusion, you must first pair the
FOXGRIP device with your Fusion remote control.
Pairing the FOXGRIP to your Fusion Remote:
1. Make sure that your FOXGRIP has a fresh battery installed.
2. Access the FOX FEATURES menu and locate the FOXGRIP Unit ID
menu option.
3. Push the “Play/Select” button a single time. A message will
appear stating “Activate FOXGRIP to pair now.”
4. Push the button on your FOXGRIP. The Fusion remote will detect
the signal and then display the FOXGRIP Unit ID to the right of
the menu item.
After the FOXGRIP device is paired with your Fusion remote, the next
step is to determine what feature you would like to assign to FOXGRIP.
The following options are available: FOXDATA, mute, auxiliary, preset 5,
preset 4, preset 3, preset 2, and preset 1. To disable FOXGRIP, set this
to off.
Assigning a feature to FOXGRIP:
1. Access the FOX FEATURES menu and locate the FOXGRIP menu
item.
2. Push the “Play/Select” button and then use the scroll buttons to
cycle through the available options.
3. After locating the desired option, push the “Play/Select” button
to lock it in.
To Next Page
Loading...
