Foxpro FUSION - Auto off; Date; Time(R); Stand Timer & Timer Reset

46
button at the same time. A single press of the power button will wake it
up without causing any changes in operation.
7-5 Auto Off
After being idle for an established period, the Fusion remote control
will completely power down. When this happens, the remote must be
powered back on like normal. There are five different time settings that
you can use for configuring the auto power off: 30 minutes, 45 minutes,
1 hour, 2 hours, and 4 hours.
Configuring Auto Off:
1. Access the Display/Power menu and select “Auto Off.”
2. Use the scroll buttons to cycle through the available time spans.
3. When set to the desired time, push “Play/Select” to lock it in.
8. Date / Time(r)
The Date / Time(r) menu provides access to the date and time
configuration, stand timer configuration, and the stand alarm.
8-1 Stand Timer & Timer Reset
When activated, the far right indicator on the bottom status line will
begin keeping time that has elapsed since the Fusion remote has been
powered on. The timer displays as: “MMM:SS” (“M” stands for minutes
and “S” for seconds). The stand timer begins tracking time as soon as
the Fusion remote is turned on.
Turning on the Stand Timer:
1. Access the Date/Time(r) menu and select “Stand Timer.”
2. Use the scroll buttons to change between off and on.
3. When set to the desired position, push “Play/Select” to lock it in.
Resetting the Stand Timer:
1. Access the Date/Time(r) menu and select “Timer Reset.”