75
• The remote control—the caller should always be higher.
• If you are using the Fusion remotely from a long distance, be
sure to allow enough time for device reaction before sending
multiple signals. For example, if you request a sound change,
consider the amount of time from radio transmission from the
remote to the Fusion until that signal is turned into a change in
operation that you can perceive. It will not always be
instantaneous and may take a second or two before a change in
operation is detected from your vantage point. Mashing down
button after button can get the device into a state of confusion
which could result in undesirable results.
• If you are operating around another Fusion user, make sure that
you are both on different channels to prevent any interference.
16. FCC & IC Information
FCC Information
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or circuit different that to
which the receiver is connected.
To Next Page
Loading...
