47
2. Push “Play/Select” to reset the timer.
To get the clock back on the display, simply set the stand timer to off.
8-2 Alarm
The Fusion remote features a visual alarm that can be set to go off after
a span of time. The available times are represented in minutes: 1 – 60.
When the alarm is set and the configured time span passes, the stand
timer (or clock if set to display the clock) will begin to flash alerting you.
The alarm is based upon the stand timer only, not the real time clock.
Keep in mind that the stand timer begins tracking time as soon as the
Fusion remote is turned on. Make sure that you select the Stand Timer
Reset option (described earlier on this page) when setting up the alarm.
For example, if you turn on the Fusion remote and 10 minutes have
passed while getting setup, and then you set the alarm for 30 minutes,
it’s going to go off 20 minutes later unless you use the Stand Timer
Reset prior to setting the alarm. Also, if the screen timeout occurs prior
to the alarm going off, it will turn back on when the alarm goes off.
Setting the Alarm:
1. Access the Date/Time(r) menu and select “Alarm.”
2. Use the scroll buttons to select the desired amount of time in
minutes. To shut off the alarm, simply change the value to off.
3. Push “Play/Select” to set the alarm.
8-3 Time
The Fusion remote has a real time clock. This clock must be set when
you first install or change batteries.
Setting the Clock:
1. Access the Date/Time(r) menu and select “Time.”
2. Use the scroll buttons to set the current time.
3. Push “Play/Select” to lock it in.
To Next Page
Loading...
