53
the remote to a computer, you will need to obtain a mini-USB type A/B
cable.
IMPORTANT NOTE
• Before connecting the Fusion remote to a computer, be sure
that it has fresh batteries installed. The Fusion remote must be
powered on while connected to a computer. If the device loses
power while connected to a computer during a write-mode,
there is a possibility of corruption of the file system. Make sure
the batteries are fresh to prevent any damage from occurring.
Connecting the Fusion Remote to a Computer:
1. Connect the USB cable from the jack on the Fusion remote to a
USB port in the computer.
2. Power on the Fusion remote. The screen should activate and
show “USB Active” instead of the sound screen.
3. Your operating system will then detect the device and take the
necessary steps to make it accessible for you. Windows users
will see a new drive letter appear named “TX1000”. Mac users
may see an icon appear on their desktop titled “TX1000”.
IMPORTANT NOTE
• Depending upon your computer setup and operating system,
the exact details of what will happen when you connect the
device may vary slightly. In general, the operating system will
detect that a piece of hardware has been detected. From there,
you should receive some sort of visual or audible notification
that something has been plugged in.
When the Fusion remote is connected to a computer, you can browse
through the device just as you would any other USB storage device.
Inside of the file system, you should encounter two files. These files are
To Next Page
Loading...
