66
Instruction: S a [b] Parameters: a (0 – 999) b (0 - 100) Description: Plays
the referenced sound number (a). The desired amount of times (b). By
not specifying how many times to play the sound, it plays a single time.
Instruction: V a Parameters: a (0 – 40) Description: Sets the volume
level. The volume level remains active until the next volume instruction
is encountered.
Instruction: P a Parameters: a (1 - 600) Description: Pauses unit
operation for a desired number of seconds.
Instruction: H a Parameters: a (1 – 1440) Description: Pauses unit
operation for a desired number of minutes.
Instruction: B a Parameters: a (0 – 19) Description: FOXPITCH
activation and parameter. 10 is normal pitch any number below slows
the pitch and number above 10 raises the pitch.
Instruction: M a Parameters: (0 – 4) Description: FOXMOTION and
speed parameter.
Instruction: L a Parameters: a (1 – 1440) Description: Loop the
proceeding instructions for (a) minutes until the end of loop (E) is
encountered.
Instruction: E Parameters: n/a Description: End of loop. Must appear
at the end of an instructional loop.
Instruction: A a Parameters: a (0 – 1) Description: Set the state of the
auxiliary signal line. Can be used if the signal state needs to be held
steady for control of the connected device. 0 = off 1 = on
Instruction: D a Parameters: a (0 - 1) Description: Set connected decoy
to on or off. 1=activate decoy 0=deactivate decoy
To Next Page
Loading...
