73
Problem: Fusion remote not controlling Fusion Solution: Make sure
that the remote and caller are set to the same channel of operation.
Then turn off the caller and remote, wait a few moments, turn them
back on and try operating again.
Problem: Cannot transfer sound list to Fusion remote Solution: Make
sure that the remote and caller are set to the same channel of
operation. Keep the remote control near the Fusion caller.
Problem: Fusion remote does not turn on Solution: Try replacing the
batteries.
Problem: Fusion remote stuck on start-up screen Solution: Try
replacing the batteries.
Problem: External speaker does not play Solution: If you have the
speaker connected to the front external speaker jack, make sure that
the right speaker is not disabled in the Fusion remote, and vice versa
with the rear external speaker jack. The external jacks are linked
left/right accordingly.
Problem: Cannot control external decoy Solution: If you are using a
FOXPRO Predator Decoy, make sure that the AUX configuration is set to
momentary and not latched. If you are using a third-party decoy, try
using the latched setting instead of momentary.
Problem: Having trouble with programming new sounds Solution:
Check out FOXPRO’s website for detailed programming information for
your Fusion. Solutions for many common issues can be found there.
Problem: Poor battery life in extreme cold weather conditions Solution:
Cold weather operations can take a serious toll on alkaline batteries. It
is strongly recommended that you use lithium or rechargeable NiMH
batteries to get the best performance in cold weather.
To Next Page
Loading...
