FRAMOS Industrial Depth Camera D400e Series - User Manual
Version 1.6.0
from 2021-10-15 51 of 64
Figure 29 – Tool UpdateFirmware Parallel Part 2
On firmware update procedure completion, the
UpdateFirmware
tool will list cameras with
corresponding firmware update status message (firmware update pass / fail).
When performing firmware update on multiple cameras, it is
recommended to perform firmware update on smaller batch first and verify result,
and then update firmware on other cameras.
9.2 Firmware Update Non-Interactive Mode
In non-interactive mode no additional input from the user is required once the tool is started. User
can select to perform firmware update on single camera, all available cameras, or a set of cameras
specified by camera serial number. Serial number argument ("-sn") must be specified after the
argument “-noninteractive”. Usage examples for Linux are shown below.
Perform firmware update on a single camera:
./UpdateFirmware FRAMOS_D415e_r1111_v1_7_0_0.fw_update -noninteractive -sn=6CD146030D2C
Figure 30 – Selecting one device in noninteractive mode
To perform firmware update on a set of cameras, specify serial numbers of the selected cameras
after the "-sn" argument and separate them with comma sign delimiter (no spaces are allowed):
To Next Page
Loading...