General
Device concept The 2.0 calibration system is designed
for calibrating power sources.
All types of Fronius power sources can
be calibrated under static load using
this system.
Both DC and AC devices can be calib-
rated.
The calibration system is suitable for
quick and easy calibration of the power
source in situ.
The calibration system can also be
used for servicing to test or check the
power sources (e.g. after repairs,
troubleshooting, etc.).
Proper use / in-
tended purpose
The device is only intended to be used for calibrating and testing welding systems
and power sources.
Any use above and beyond this purpose is deemed improper. The manufacturer
shall not be liable for any damage resulting from such use.
Proper use also includes
-
carefully reading these Operating Instructions
-
following all the instructions and safety rules in these Operating Instructions
-
performing all stipulated inspection and maintenance work
The device is designed for use in industry and the workshop. The manufacturer
accepts no responsibility for any damage caused through use in a domestic set-
ting.
15
EN
To Next Page
Loading...
Need help?
General