Contents
Safety rules 5
Explanation of safety notices 5
General 5
Proper use 6
Environmental conditions 6
Obligations of the operator 6
Obligations of personnel 6
Mains connection 7
Protecting yourself and others 7
Risks from mains current and welding current 7
EMC Device Classifications 8
EMC measures 8
EMF measures 9
Specific hazards 9
Danger from shielding gas cylinders 10
Safety measures at the installation location and during transport 10
Safety measures in normal operation 11
Commissioning, maintenance and repair 11
Safety inspection 11
Calibration of the calibration system 11
Disposal 12
Safety symbol 12
Data protection 12
Copyright 12
General information 13
General 15
Device concept 15
Proper use / intended purpose 15
Crane transport 16
Accessories and options 17
Interface and trolley 17
Accessories 17
Options 19
Required for calibration 20
Computer & software 20
Hardware & accessories 20
Required for calibration of the WeldCube Connector 20
Controls, connections and mechanical components 23
Controls and connections on calibration system 25
Front of device 25
Rear of device (without trolley) 26
Mechanical components on trolley 27
Calibration system trolley 27
Installation 29
Installing the calibration system 31
General 31
TwinCat 31
USB to LAN driver(Windows® 7) 31
TPS/i SmartCard driver 32
LocalNet FTDI driver 33
Desktop software installation 33
Changing network settings 34
Changing the network settings for USB calibration 34
Setting a TwinCat route 35
Setting the language, system information 37
3
EN
To Next Page
Loading...
Need help?
General