Fronius MIG/MAG - Device Concept; Areas of Utilisation; Scope of Supply

58
Device concept The CrashBox Drive /i is designed specifically for fitting to the robot arm and for holding
gas-cooled and water-cooled robot hosepacks with robot drive units. For PAP systems, the
torch hosepack runs through the CrashBox and then through the robot arm. In convention-
al robot systems the torch hosepack runs along the robot arm and is attached to the clamp.
In the event of a crash, the magnetic coupling smoothly deflects the forces along a large
deflection path.
Areas of utilisa-
tion
The clamp system can be used for the following PushPull robot hosepacks:
- MHP /i G/W RD hosepacks
Scope of supply
CrashBox Drive /i PAP scope of supply Conventional CrashBox /i scope of supply
(1) CrashBox Drive /i holder
(2) 1-ear clamp *
(3) Locking ring, 2-part *
(4) Bellows
(5) Cheese-head screws, M4 x 16 mm
(6) Magnetic ring
* A two-part locking ring and a 1-ear clamp are supplied fitted to the bellows (4).
Do not fit the CrashBox Drive /i holder (1) and magnetic ring (4) together before fitting to
the robot. The components become even more difficult to release due to the strong mag-
netism.
(1) (2)(3) (2)(3)(4) (5) (6)
(1) (2)(3) (4) (5)(6)(2)(3)