Fronius MIG/MAG - Fitting the SB 60 I R to the Robot; Fitting the SB 60 I R to the Balancer

86
Fitting the SB 60i
R to the robot
NOTE!
Depending on the robot, please also note the instructions and information in the
User Information on installing the holding plate for the SplitBox.
The installation of the SplitBox SB 60i R is illustrated using the right version of the appli-
ance. The left version of the appliance should be installed the other way around.
1 2
Fitting the SB 60i
R to the balancer
NOTE!
► Use a balancer with a load capacity of at least 18 kg
► Use a second balancer for hosepacks longer than 1.75 m. Position the balancer half-
way along the length of the hosepack.
1 2
1
2
1
2