Fronius MIG/MAG - Robot Welding Torch; Safety; General

59
EN
Robot welding torch
Safety
CAUTION!
Risk of burns from hot torch body, hot torch body coupling and other hot welding
torch components.
Before starting work on the torch body, the torch body coupling and all other welding torch
components:
► Allow the torch body, torch body coupling and all other welding torch components to
cool down to room temperature (+25 °C, +77 °F)
► Wear electrically insulated and heat protective gloves
► Use a suitable tool
General The following torch bodies are recommended for the CMT process:
- MTB 250i / 320i / 400i / 500i / 700i: 22 - 36°
- MTB 330i: 22°
The following maximum angles are permitted during the CMT process:
- MTB 250i / 320i / 400i / 500i / 700i: 45°
- MTB 330i: 36°
The robot welding torch transmits the arc power to the workpiece. The gas or water-cooled
TPS/i welding torch is designed for use with the CrashBox /i.
The torch body has an integrated lead for gas nozzle touch sensing.
Standard:
With wearing parts, without contact tip
OVT:
Without wearing parts
TXi:
Automatic torch body changeover
TXM:
Manual torch body changeover