Fuji Xerox DocuCentre-IV 2060 Administrator's Guide

15 Problem Solving
418
Problem Solving
15
016-461
[Cause] When [Assurance Level] under the [Transfer Image Log] is set to [High], you
may not be able to create a new job because of a restriction resulting from the
congestion of un-forwarded image logs.
[Remedy] Confirm the status of the server managing the image logs and the network
status, and eliminate the source obstructing image log forwarding to the
image log server. Take one of the following measures:
z
Confirm the forwarding settings, and then forward all un-forwarded logs.
z
Change the [Assurance Level] to [Low]. In this case, the image logs may
not be forwarded and may be deleted successively.
When using the Image Log Kit (Adobe PostScript), and you switch the
machine power off and then on, or when the machine restarts automatically,
switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power.
016-500
016-501
016-502
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
016-503
[Cause] Unable to resolve the SMTP server name when sending e-mail.
[Remedy] Check on CentreWare Internet Services whether the SMTP server settings
are correct. Also, confirm whether the DNS server settings are correct.
016-504
[Cause] Unable to resolve the POP3 server name when sending e-mail.
[Remedy] Check on CentreWare Internet Services whether the POP3 server settings
are correct. Also, confirm whether the DNS server settings are correct.
016-505
[Cause] Unable to log into the POP3 server when sending e-mail.
[Remedy] Check on CentreWare Internet Services whether the user name and
password used on the POP3 server are correct.
016-506
[Cause] Unable to write the image log because the image log storage space is
insufficient on the machine.
[Remedy] Execute the job again. If the error still is not resolved, take one of the
following measures:
z
Delete unnecessary image logs
z
Change the [Assurance Level] for image logs to [Low]
In this case, the contents of the logs is not secured.
016-507
[Cause] When using the Image Log Control feature, failed to forward the image log to
the server.
[Remedy] Either set the forwarding rule for image logs from the server to the machine,
or set [Transfer Image Log] to [Disabled].
016-508
[Cause] When using the Image Log Control feature, failed to forward the image log to
the server.
[Remedy] Set the forwarding rule for image logs from the server to the machine.
016-509
[Cause] When using the Image Log Control feature, failed to forward the image log to
the server because the forwarding rule for image logs from the server to the
machine has not been set.
[Remedy] Either set the forwarding rule for image logs from the server to the machine,
or set [Transfer Image Log] to [Disabled].
016-510
[Cause] When using the Image Log Control feature, failed to forward the image log to
the server because the forwarding rule for image logs from the server to the
machine has not been set.
[Remedy] Set the forwarding rule for image logs from the server to the machine.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Downloaded From ManualsPrinter.com Manuals

Fuji Xerox DocuCentre-IV 2060 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 2060
Category	All in One Printer
Language	English