Error Code
471
Problem Solving
15
033-710
[Cause] The document to be sent by polling was deleted.
[Remedy] Store the document again.
033-712
[Cause] Unable to process because of insufficient memory.
[Remedy] Delete unnecessary data.
033-713
[Cause] An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
033-716
[Cause] The folder specified from the sender's machine does not exist.
[Remedy] Register the folder.
Refer to "Create Folder" (P.202).
033-717
[Cause] The folder passcode specified from the sender's machine is incorrect. Or, the
machine passcode for reception is incorrect.
[Remedy] Inform the correct information to the sender's machine.
033-718
[Cause] Fax or polling documents do not exist in the folder specified from the sender's
machine.
[Remedy] Store fax or polling documents into the folder as necessary.
033-719
[Cause] The document may be deleted by turning the machine off and then on.
[Remedy] Retry sending.
033-721
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the error still is not resolved, contact our
Customer Support Center.
033-724
[Cause] The reception was interrupted because the image volume exceeded the
upper limit.
[Remedy] Install the Extension System Memory to increase the maximum volume of
image data.
033-725
[Cause] The hard disk is full.
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
033-726
[Cause] The received document was printed with 1 sided printing, because 2 sided
printing is not available for mixed sized documents.
[Remedy] No measure is required.
033-728
[Cause] The auto print formatting of the received fax document was interrupted by a
manual print operation.
[Remedy] No measure is required. The machine will automatically start the auto print
job after manual printing completes.
033-731
[Cause] The printing of the received fax document was interrupted.
[Remedy] The auto print processing of the received fax document was interrupted by a
manual print operation. No measure is required.
033-732
[Cause] An error occurred while connecting to EP system.
[Remedy] This is an error occurring during maintenance work by Fuji Xerox. No
measure is required.
033-733
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the error still is not resolved, contact our
Customer Support Center.
033-734
[Cause] Because a report job was instructed while preparing to print a received fax,
the printing of the received fax is temporarily suspended.
[Remedy] No measure is required.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
