15 Problem Solving
472
Problem Solving
15
033-735
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the error still is not resolved, contact our
Customer Support Center.
033-736
[Cause] The forwarding job was interrupted because the data volume exceeded the
upper limit.
[Remedy] No measure is required.
033-737
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
033-738
[Cause] Received abnormal JBIG data.
[Remedy] No measure is required.
033-740
[Cause] The printing of the received fax document was interrupted.
[Remedy] No measure is required.
033-741
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved, contact our
Customer Support Center.
033-742
[Cause] An error occurred during fax transmission. This error may occur if the
remaining capacity of the machine’s memory is 10% or less and Manual Send
is used.
[Remedy] If this error was caused when using Manual Send, connect the line after
storing the document, and then send. If the error still is not resolved, delete
unnecessary data from the hard disk to free up disk space, and execute the
operation again.
If the error persists, contact our Customer Support Center.
033-743
033-744
033-745
033-746
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. Try again. If the error still is not resolved,
contact our Customer Support Center.
033-747
[Cause] The job is temporarily suspended.
[Remedy] No measure is required.
033-749
[Cause] The machine will automatically recover and print the document.
[Remedy] No measure is required.
033-750
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. Try again. If the error still is not resolved,
contact our Customer Support Center.
033-751
[Cause] An activity report output occurred during the printer lockout duration.
Outputting the activity report was suspended because the machine was in the
Sleep mode.
[Remedy] No measure is required because the machine will output the report after
exiting the Sleep mode.
041-310
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
