Fuji Xerox DocuCentre-IV 2060 Administrator's Guide

Error Code
473
Problem Solving
15
041-325
041-326
041-327
041-328
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
041-329
041-330
041-331
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
041-340
041-341
041-342
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
041-388
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
042-310
Cause] An error occurred in the machine.
[Remedy] Contact our Customer Support Center.
042-323
042-338
042-400
045-310
045-311
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
047-211
[Cause] An error occurred in the Offset Stacking Unit.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
047-213
[Cause] Detected the installation of a finisher of a different type than expected.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
047-216
[Cause] An error occurred while detecting the finisher.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
047-217
[Cause] An error occurred while detecting Tray 6 (HCF A4 1).
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
047-320
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
059-314
059-315
059-316
059-317
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. If the same message is displayed again,
contact our Customer Support Center.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Downloaded From ManualsPrinter.com Manuals

Fuji Xerox DocuCentre-IV 2060 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 2060
Category	All in One Printer
Language	English