Faxing 189
Receiving a Fax Manually Using an External Telephone
This feature works best when you are using an external telephone connected to the phone connector ( ) on the
rear of your printer. You can receive a fax from someone you are talking to on the external telephone without having
to go to the printer.
When you receive a call on the external telephone and hear fax tones, press the two-digit keys on the external
telephone.
The printer receives the document.
Press the buttons slowly in sequence. If you still hear the fax tone from the remote machine, try pressing the two-
digit keys once again.
Remote Receive is set to Off at the factory. You can change the two-digit number to whatever you choose. For
details on changing the code, see "Remote Receive" on page 225.
NOTE:
• Set the dialing system of your external telephone to DTMF.
Receiving Faxes Using the DRPD Mode
The Distinctive Ring Pattern Detection (DRPD) is a telephone company service which enables a user to use a single
telephone line to answer several different telephone numbers. The particular number someone uses to call you on is
identified by different ringing patterns, which consist of various combinations of long and short ringing sounds.
Before using the DRPD option, Distinctive Ring service must be installed on your telephone line by the telephone
company. To set up DRPD, you will need another telephone line at your location, or someone available to dial your
fax number from outside.
To set up the DRPD:
1 Press the (System) button.
2 Select the Tools tab, and then select Admin Settings.
3 Select Fax Settings.
4 Select Fax Line Settings.
5 Select DRPD Pattern.
6 Select the desired pattern, and then select OK.
7 Reboot the printer by turning the power switch off and then on again.
To receive faxes in the DRPD mode, you need to set the menu to DRPD Mode. For details, see "Available Fax
Setting Options" on page 200.
See also:
• "DRPD Pattern" on page 222
Receiving Faxes in the Memory
Since your printer is a multi-tasking device, it can receive faxes while you are making copies or printing. If you
receive a fax while you are copying, printing, or run out of paper or toner, your printer stores incoming faxes in the
memory. Then, as soon as you finish copying, printing, or re-supply the toner cartridges, the printer automatically
prints the fax.
To Next Page
Loading...
Need help?
General
